I received an nintendo 64 usb controller and tried to use it to play (this one ).

So I put it,used this tutorial to install it and I can see with jstest that it's working. So I installed mupen64plus and M64Py for the gui, so the gui recognize my controller, but I cannot use it. I saw on the post How do you configure mupen64plus controls? that I'm using the same controller than on the image tbe DragonRise inc one, but every time I change the controls and press enter or click on close it's just change all the controls by something per default like this:

DPad R = "key(100)"

DPad L = "key(97)"

DPad D = "key(115)"

DPad U = "key(119)"

Start = "key(13)"

Z Trig = "key(122)"

B Button = "key(306)"

A Button = "key(304)"

C Button R = "key(108)"

C Button L = "key(106)"

C Button D = "key(107)"

C Button U = "key(105)"

R Trig = "key(99)"

L Trig = "key(120)"

Mempak switch = "key(44)"

Rumblepak switch = "key(46)"

X Axis = "key(276,275)"

Y Axis = "key(273,274)"

Normally the buttons should be like button 1,2,3 etc

I tried with the gui and without the gui but I cannot make this controller workinf :/ Thanks for reading and sorry for my poor english

1 Answer

You should ask this question on the mupen64 forums, asking us will get you nowhere.

It's probably mupen64s fault.

Your Answer

Sign up or log in

Sign up using Google Sign up using Facebook Sign up using Email and Password Submit

Post as a guest

Post Your Answer Discard

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy